Why won't my key turn in the ignition?
Start with the quick checks. Many vehicles lock the steering wheel when the key comes out, and if the wheel was turned while parked, that lock binds. Gently wiggle the wheel left and right while turning the key, and it often lets go. On automatics, make sure the shifter is fully in Park.
If that doesn't do it, the cause is usually wear. Inside the cylinder are small spring-loaded wafers that line up with the cuts on your key. Over years of use, both the wafers and the key wear down until they stop lining up. The key turns some days and not others, and then one cold morning it doesn't turn at all.
Signs your ignition cylinder is wearing out
- The key only turns after jiggling it or pulling it slightly out.
- The key sticks and won't come out, even in Park.
- The cylinder feels loose or moves in the column when you turn it.
- The key goes in but won't turn, even with the wheel free.
- A spare key works better than the one you use every day.
That last one is a clue. If a lightly used spare turns easily, your everyday key may be the worn part, and a freshly cut key from our key cutting service may fix it without touching the ignition.

Rebuild or replace the cylinder
A rebuild takes the cylinder apart, replaces the worn wafers and springs, and puts it back so your same key works smoothly. It fits when the housing is sound and only the parts inside are tired.
A replacement puts in a new cylinder when the old one is cracked, damaged or was forced. The new cylinder can be matched to your existing key, so one key still runs the doors and the ignition, or rekeyed to a new key if you'd rather start fresh. If what we find differs from what you described on the phone, the new price is explained before any extra work.
Push-to-start problems that are really fob problems
A push-button car has no cylinder to wear out, but key-not-detected messages are common, and most of the time the fob battery is weak. Treasure Valley winter mornings are hard on coin batteries, so the problem often shows up on the coldest day.
Many push-button cars have a backup spot where a weak fob can still be read, often by holding the fob against the start button. Your owner's manual shows where. If a fresh battery doesn't help, the fob may need repair or replacement.

When it isn't the ignition
If the key turns fine but the engine cranks without starting, or the security light flashes, the car may not be reading the chip in your key. That's a programming issue, not a cylinder issue. If the key turns and nothing happens at all, the car battery or the electrical switch behind the cylinder may be at fault, and we'll tell you if that's work for a mechanic.
Key snapped off in the cylinder? That starts with broken key extraction.
How it works
- Call with the symptomsTell us the vehicle and what the key does: sticks, won't turn, feels loose or won't come out. We quote it by phone.
- Find the real causeWe check the key, the steering lock and the cylinder before replacing anything.
- RepairRebuild, replace or cut a fresh key, whichever solves it.
- TestWe turn the key through every position, start the car and try the same key in the doors.


